Costa Mesa is home base for Wilson Electric, and its housing stock explains why subpanels come up here so often. Many homes were built in the 1950s and 1960s on deep lots with detached or tuck-under garages. Today those same lots are getting ADUs, garage gyms, EV chargers and second-story additions. All of that has to be powered through a service that was often sized for a much smaller house.
| Costa Mesa Subpanels: Quick Answers
| Who: Wilson Electric, a licensed C-10 electrical contractor (#1108912) based in Costa Mesa, serving Costa Mesa.
| Most common Costa Mesa projects: Eastside ADU Behind an Older Cottage; Mesa Verde Garage Turned Workshop; Second-Story Additions.
| Key fact: A subpanel adds breaker space, not capacity. We confirm your service has room with a load calculation.
| Permits: Permitted and inspected through the City of Costa Mesa Building Division.
| Code: The 2025 California Electrical Code, in effect statewide since January 1, 2026.
| Cost: An itemized written estimate after we see your main panel and the route.
| Why Costa Mesa Homes Add Subpanels
Postwar ranch homes on the Westside and in Mesa Verde often still have 100-amp services, or even smaller ones, with a panel that has no open spaces left. On the Eastside, older cottages are being torn down or rebuilt into larger custom homes, and those projects often need a panel for each wing. Costa Mesa has also seen a large number of ADU permits, and many of them end up behind homes whose main panel was never planned to carry a second household. Our first step is almost always a load calculation, because the right answer can be a subpanel, an upgraded service, or both.
​
| Costa Mesa Neighborhoods We Serve
​
| Eastside Costa Mesa
| Westside Costa Mesa
| Mesa Verde
| College Park
| Halecrest
| Mesa del Mar
| South Coast Metro
| Wimbledon Village
| Subpanel Projects We See in Costa Mesa
| Eastside ADU Behind an Older Cottage
​
A typical Eastside lot has an older house up front and a new ADU going in at the back. We check whether the existing service can carry both households. If it can, we run a feeder to a subpanel in the ADU and install the outdoor emergency disconnect the 2025 code expects. If it cannot, we plan a service upgrade and a separate meter instead.
​
| Mesa Verde Garage Turned Workshop
​
Single-story Mesa Verde homes often have the panel on the garage wall, which makes a garage subpanel inexpensive to feed. We add dedicated circuits for a compressor, dust collector and EV charger, and leave space for later.
​​​
​
​
| Second-Story Additions
​
When a home adds a second story, a subpanel upstairs keeps the new circuits organized, shortens runs and keeps the inspector's job simple. We rough it in before drywall so nothing has to be opened up later.
​
​
Salt air note: on this part of the coast, we use outdoor-rated, corrosion-resistant enclosures, stainless or coated hardware where there is direct spray, and sealed conduit entries.
| Space or Power? The Question to Answer First
A subpanel gives you more breaker spaces. It does not give your home more power. Every amp still comes through your main service, so if that service is already near its limit, a subpanel just moves the problem. We run a load calculation on your Costa Mesa home before recommending anything. If the numbers work, a subpanel is usually the most affordable fix. If they do not, we will explain a main panel upgrade, a SPAN smart panel or EV load management.
| What We Check at Your Costa Mesa Home
| Whether your existing service, often 100 amps on older Westside and Mesa Verde homes, can carry the new load
| Service size, panel condition and open breaker spaces
| Feeder route and distance, and the wire size needed to limit voltage drop
| Panel location, working clearance and grounding
| Plans for EVs, batteries, heat pumps or other future loads
| How a Costa Mesa Subpanel Installation Works
Here is how a typical subpanel installation in Costa Mesa works, from the first visit to final inspection:
​
1. Estimate visit: we look at your main panel, the open spaces and the feeder route.
2. Load calculation: we confirm your service can support the new feeder.
3. Itemized proposal: panel size, feeder size, route, permit and patching are all listed.
4. Permit: Filed with the City of Costa Mesa Building Division.
5. Installation: panel set with code clearances, feeder run, neutrals isolated from grounds.
6. Inspection and handover: we meet the inspector, test each circuit and label the panel.
| Subpanel FAQs for Costa Mesa Homeowners
| Can my Costa Mesa home handle an ADU on the existing service?
Sometimes. Many older Costa Mesa homes have 100-amp services, and an all-electric ADU can push that past the limit. We run a load calculation for both units before recommending a subpanel or a separate meter.
​
| Do you install subpanels in Costa Mesa condos and townhomes?
Yes, where the HOA and the building's electrical layout allow it. Many townhomes have the main panel in the garage, which is a practical spot for a small subpanel for an EV charger.
​
| How close are you to my Costa Mesa home?
Wilson Electric is based in Costa Mesa, so we can usually get to your home for an estimate quickly, and we know how the City of Costa Mesa's permit and inspection process works.
​
| Does a subpanel increase capacity in my Costa Mesa home?
No. A subpanel adds breaker spaces, but all of its power still comes through your main service. If your service is near its limit, we will recommend a service upgrade, a SPAN smart panel or load management.
​
| Do I need a permit for a subpanel in Costa Mesa?
Yes. Permits and inspections go through the City of Costa Mesa Building Division. We pull the permit and meet the inspector.
| Related Services and Nearby Cities
• Electrical Subpanel Installation in Orange County
• Whole Home Rewiring in Costa Mesa
• Panel Upgrades in Costa Mesa
• Subpanel Installation in Newport Beach
• Subpanel Installation in Huntington Beach
• Subpanel Installation in Santa Ana
• Subpanel Installation in Irvine
• Subpanel Installation in Fountain Valley

